Shure SE215
Shure SE215 are in-ear earphones with a single small MicroDriver that singers and musicians wear as in-ear monitors on stage, and many people also use for everyday listening. The cable runs over and behind the ear, so the earphones stay in place when you move and the cable transmits less rustling from clothing. On this page you will find SE215 in clear and black finishes, EAC64 replacement cables and a separate left earpiece. The cable detaches from the earphones at the MMCX connector, so if it is damaged, you only replace the cable rather than the earphones.
How do the SE215 reduce outside noise?
The SE215 have a closed design and silicone tips that seal the ear canal in a similar way to earplugs. They reduce stage or traffic noise passively, without active noise cancellation (ANC) or a battery. A good seal is essential: if a tip does not fit properly, bass becomes weaker and outside sounds get in, so try out the sizes to find one that stays in your ear. The earphones do not have a microphone and are not suitable for phone calls. A protective case is also included.
What do 17 Ω and 107 dB mean for in-ear monitors?
An impedance of 17 Ω and sensitivity of 107 dB mean the SE215 can play loudly even from a phone, portable player or wireless in-ear monitoring receiver. The frequency range of 22 Hz to 17.5 kHz covers kick drum, bass guitar and vocals, which are what a musician needs in a monitor mix. The 3.5 mm jack plugs directly into a receiver, or into the headphone output of a mixing desk using an adapter.
Which EAC64 cable fits, and what is the separate earpiece for?
The EAC64 cable is 1.62 m long, with two MMCX connectors for the earphones at one end and a 3.5 mm stereo jack at the other. It fits the SE215, SE315, SE425 and SE535, while the clear EAC64CL also fits the SE846. The separate left SE215 earpiece has the same specifications as the pair and replaces a lost or damaged earpiece without buying a complete set. You can find microphones and the brand’s other equipment on the Shure page.